Aquamist system plumbing

[macca]

Hi,

Anybody know the hose size for an Aquamist system please?

Cheers,

Mark.

[Tricky-Ricky]

Feed to pump 6mm, from pump to jet 4mm, just give me a shout when you want to fit it, and I'll give you a hand Mark:)

[macca]

That's great Dick, thanks. Appreciate the offer of help too. You may regret that ;)

It won't be until I get back on my feet properly, but I know there's some bits missing form the kit I bought so am trying to get what I need together.

I've got a washer (primer) pump now, and the hose will be here soon. I bought a tank ages ago for it.

Any ideas on what would be a good jet size for my standard twins and up to about 1.3-1.4bar boost?

Cheers,

[Tricky-Ricky]

I think i was using 0.8 or 0.9mm, bur i did swap over to two smaller jets at slightly different locations, simply because the smaller jets have better atomisation.
Have you got a pre trigger timer for the priming pump? or have you got the DDS3 box?

[macca]

Ermmmmm..!

I'm not sure what I've got to be honest, I'll have to bring the box round to you and see what you can make of it. Aquamist weren't very helpful and I tried checking what I have against the parts list but wasn't overly sure of it all.

It's obviously been well used and then removed without too much care and attention. Hopefully it'll all work ok!